wind sin65 build manual

1.Install the round rubber feet into the bottom case.

   将底壳安装上硅胶脚垫

   

2.Install the weight.

   安装配重

   

3.Install weight with M2X4 screws

  用M2X4沉头螺丝将配重固定

  

4.Install type c daughterboard into bottom case with M2X5 screws.

   用M2X5平头螺丝将type-小板固定到底壳

   

5.Put battery foam into battery slot for wired version.

   Put battery into battery slot and connect battery with type c daughterboard for bluetooth version.

   组单模版本时将电池棉放入电池槽位，双模版本放入电池

   

6.Install silicone stand holder into the bottom case.

   将硅胶支撑柱安装到底壳对应位置

   

7.Put 1mm case foam into case(depend on your favourite).

   将1mm底棉放入底壳(根据个人喜好放入)

   

8.Put 2mm hotswap foam into case into case((depend on your favourite).

   将2mm热插拔棉放入底壳(根据个人喜好放入)

   

9.Install pcb stabilizer, install standoffs with M2X3 screws.

   安装卫星轴，使用M2X3平头螺丝安装铜柱

   

10.Put 0.5mm IXPE sheet,3.5mm foam onto PCB

     (Need to replace 5mm foam instead of 3.5mm if you want to build plateless mount,only support plateless mount on soldered pcb)

     依次安装0.5mm轴下垫和3.5mm夹心棉(如果组无钢结构，需要将3.5mm夹心棉更换为5mm夹心棉)

    

11. Put on the plate

      将定位板安装上

      

12.Fixed the plate with M2X3 screws

     使用M2X3沉头螺丝将定位板固定

     

13. TOP mount or Gasket mount build

      组TOP结构或者Gasket结构

① Top mount build

Stick the silicone part onto the plate

将TOP硅胶块粘到定位板上对应位置

     

Fixed the internal structure into top case with M2X5 screws

使用M2X5的平头螺丝将内胆固定在上壳位置

    

②Gasket mount build

Stick gasket onto PCB

将gasket棉条粘到PCB对应位置

     

14.Connect pcb with type c daughterboard

     PCB与底壳type-c连接

     

15.Fixed top case and bottom case with M2.5X8 screws.

     用M2.5X8圆柱头螺丝将上下壳固定