How to keymap for wind x r2 keyboard？
Check your pcb style first：
1. Normal keyboard- wired hotswap pcb（Load the json file into VIA then directly use）
Json file download VIA download
2. Normal keyboard- bluetooth wired hotswap pcb ( keymap on LDN program)
LDN download how to use LDN on wind x r2
3. Normal keyboard-soldered pcb ( keymap on VIAL)
4. Southpaw version- Enter left ( keymap on VIAL)
5. Southpaw version-Enter right（keymap on VIAL）
6. Southpaw version- soldered （kemap on VIAL）
VIAL download
Except bluetooth pcb, the other pcb also can keymap on VIA or VIAL, check below step if you want to use.
Note:
If you use VIA,pls click " Use V2 definitions(deprecated)" before you load the json file.
①Normal keyboard- wired hotswap pcb
The default firmware support on VIA, if you want to use on VIAL. Need to refresh hex vial file first and then can use on VIAL.
So after you refresh hex vial file successfully, open VIAL and then show the wind x r2 layout automatically. But if you want to use VIA again，so also need to use refresh hex via file first and then can use on VIAL.
② Normal keyboard-soldered pcb
Southpaw version- Enter left pcb
Southpaw version-Enter right pcb
Southpaw version- soldered pcb
The default firmware support on VIAL, open VIAL and then show the wind x r2 layout automatically. If you need to use VIA, there is no need to refresh, only load the corresponding json file into VIA and then can keymap on VIA.( But it can not change lighting on VIA)
The json file of normal keyboard-soldered pcb
The json file of southpaw version- Enter left pcb
The json file of southpaw version-Enter right pcb
The json file of southpaw version- soldered pcb
If you find above four pcb get some keymap problem, you can try to refresh it first.
How to refresh?
- Press 1-2-3-4 key in order at same time.
- There will show a "Wind_Studio(H)" driver on your computer list, then drag the corresponding uf2 file into this driver. Then it will refresh successfully.
The refresh uf2 file of Normal keyboard-soldered pcb
The refresh uf2 file of Southpaw version- Enter left pcb
The refresh uf2 file of Southpaw version-Enter right pcb
The refresh uf2 file of Southpaw version- soldered pcb